If you’re a woodworking hobbyist, you know how important it is to get the best dust extraction from your scroll saw. That’s because your saw is an expensive piece of equipment and you don’t want to have to constantly replace filters or spend money on dust cartridges. This will also help you avoid spending money on replacement parts if your workshop is broken down. Your goal with any woodworking project should be to finish the job as quickly as possible and minimize the need to leave your work undone. The longer you let the dust settle on your woodworking machine, the more likely it is that you’re going to have to buy new woodworking equipment. There are a few simple tips you can use for scroll saw patterns and cuts that will keep your equipment running smoothly and cleanly.
When cutting scroll saw patterns, it’s important that you make sure to wear safety glasses, a mask, or other protection. You also want to make sure you know the layout of your workshop and work area. There are a number of different things that can lead to your scroll saw getting clogged. Most of these common problems occur when you’re working off center, at an angle, or using a poor dust collection system.
An air powered machine is the best choice when it comes to creating scroll saw patterns. Because the motor is so close to the blade, the air is able to reach all the areas that you need to. A good air system doesn’t require a lot of maintenance. You just need to change the filter every so often and make sure you properly attach the air tank and hoses. Many scroll saws actually come with two tanks, one for the air and the other for the waste gas.
An electric scroll saw can be less noisy, but they don’t have nearly the same dust collection systems. Because the motor is moving the scroll saw blades, it can create a lot of noise. Electric machines don’t use compressed air, which means they don’t collect dust as efficiently.
The best type of scroll saws to purchase is the ones with the dual tanks. These scroll saws allow you to add or remove air from the tanks on the fly. This increases efficiency because you aren’t forced to stop work and change out the filters. Electric scroll saws only allow you to change the filters when the motor becomes too hot. This means you will need two power sources if you want to run both the scroll saw motors at the same time.
You also need to make sure that you take the time to clean your scroll saws regularly. Dust and dirt particles are very hard to clean up. If you use a regular broom to sweep the scroll saw, you could seriously damage it. The best option is to have it professionally cleaned every few months. This will ensure your scroll saw is working properly and will greatly reduce the risk of it breaking down.
Another option is to buy a filter to attach to the scroll saw. The best filter companies produce them specifically for scroll saws. These filters are easy to install and remove, and they are designed to trap dust so the motor doesn’t have to work so hard. These are also much easier to replace than the old fashioned filters were.
You also need to think about where you will be using your scroll saw. While the motor works well in most cases, there are certain areas that cause it to emit more dust and debris. The best dust extraction for scroll saws is going to be in the lower depths of a tile, or similar surface. Use a vacuum to suck up the dust and sweep it away from the area.